IETS GT202 Laptop Cooler External Automatic Cooling Fan with Temperature Display

4.8

Write a Review

Questions

Be More Efficient to Cool Down

This fan cooler is specially designed for notebook computers with air vents on the left side, right side, or back.

Unlike the normal cooling pad that blows the air into the laptop, IETS GT202 fan cooler extracts the heat from inside the laptop, so it can rapidly cool down in minutes. Your computer will run more smoothly and safely.

Automatic and Manual Modes Optional

This fan cooler comes with a temperature LED display. In the automatic mode, the cooler's fan speed would be automatically changed according to the laptop air outlet's temperature. While in manual mode, you can adjust up to 13 different fan speeds from 2600RPM to 5000RPM.

What's more, the working noise of this laptop cooler is also quiet. The max fan speed noise would be less than 72 dBm.

Two Installation Methods

You can use the quick installation method: simply plug and play. Or use the 3M tape with patented clamping arms to keep the cooler firmly attached to the laptop.

Compatible with 95% Laptops

The cooler comes with 3 different sizes of silicone covers for different air vent laptops. The silicone cover would prevent air leakage and improve heat dissipation efficiency greatly. And it would be compatible with almost 95% of laptops in the market: 11-inch, 13-inch, 14-inch, 15-inch, or 17-inch.

Buying Notice

Please check your laptop's air vents first before you buy this cooler. If you are not sure if this is going to work with your computer or not, please send your device's brand and model to support@tablets-world.com.

To use this cooler, your laptop should have an air vent on the sides or back, and its size must not exceed 4.6"L x 1.6"H. The smallest silicone cover is 3.3 inches in length, please make sure that size does not cover any of your laptop's necessary ports.

If the air vent is on the back, the cooler would limit your laptop's display opening angle up to 135 degrees only. What's more, the bottom surface near the air vent should be flat to be able to install the cooler by the adhesive mount.